How to set up wifi for the camera? Or (How to setup camera to the app) (how to add camera to the app)

For CAM1 check this video：https://kinetcam.com/camera-setup-by-scan-code-cam1/

For CAM3 check this video：https://kinetcam.com/camera-setup-by-scan-code-cam3/

For CAM5 check this video：https://kinetcam.com/camera-setup-by-scan-code-cam5/

Here are step by step:

Check in phone WiFi settings, make sure the phone is connecting the same WiFi
Open the KINETCAM App. Tap the "+" in the top right corner of the Devices page. Tap "WiFi Device" then "Scan Code Setup"
According to the prompts on the following pages below, tap "Next".

Note: If there is any voice prompt from the App, please ignore it and follow the instructions provided in this manual.

Confirm that the WiFi name shown here is the correct WiFi. Please note that the WiFi must be a 2.4GHz WiFi or a 2.4GHz/5GHz hybrid WiFi, and make sure the WiFi is NOT a Guest WiFi.

Input WiFi password and tap "Next". For the prompt "Attention Please", Tap "Confirm".

NOTE: Make sure the WiFi name is the target WiFi. If not, go to phone setting and choose the correct WiFi, then back to KinetCam App >> start again

The App will show a QR Code on its screen. Let the camera lens face at the phone screen read the QR Code. Make Phone is 6~14 inches away from the camera lens.

Note: Place your phone flat on the table with the camera facing downward towards the QR code on the screen. This will reduce screen glare and allow for faster scanning and recognition.

CAM1:At the same time, keep an eye on the flashing green LED on the camera, when it becomes Steady Green, the scan is successfully. You can stop letting the camera scan the code and just wait for several seconds.

Turn to STEADY GREEN

CAM3: At the same time, keep an eye on the flashing blue LED on the camera, when it becomes Steady Blue, the scan is successfully.You can stop letting camera scanning the code and just wait for several seconds.

CAM5: At the same time, keep an eye on the flashing blue LED on the camera, when it becomes Steady Blue, the scan is successfully.You can stop letting camera scanning the code and just wait for several seconds.

The App will start to find the camera, just wait for some seconds. Once the app finds the camera, the app asks to set a name to the camera, and tap "Next", "Confirm", and "Next" one by one.

A Live Video will show up in the App. Tap "Complete". Now the camera has been setup to your WiFi and the camera has been added to your phone.

Note:

As long as your phone has internet access (either via WiFi or mobile data), you can access the camera video through the App, regardless of whether you are at home, outside, or on the go.

Once the camera has been connected to your WiFi, if you turn off the camera, you only need to turn it on again (there is no need to set it up again). After you turn it on, the camera will automatically connect back to your WiFi. This process may take up to 1 minute.

Tips:

Find a location with strong WiFi signal to place the camera. Weak WiFi signal of the placement location may cause your phone is difficult to connect to camera video.
Please ensure that you have provided the correct WiFi password during the setup process. If the WiFi password is incorrect, you will notice that the green LED cannot become steady green.
After camera setup has been completed, if you need to add the camera on the second phone or third phone, no need to run the camera setup again. Just check Chapter 6 in the manual. Please click the video link, which will tell you to step by step(Pls make sure your home wifi is 2.4Ghz):

Can I view the video on the computer or browser?

Unable to join

Last modified: 2024-03-02Powered by

Outline